Stick-M-Up is a specially formulated yellow carpet adhesive remover. Stick-M-Up allows for quick removal of glued down carpet and acrylic, latex and pressure sensitive adhesives from concrete, terrazzo, ceramic tile and other surfaces. It is designed to soften carpet adhesive so that carpet may be easily removed and to allow for easy scrape removal of the carpet adhesive.
STICK-M-UP allows for quick removal of glued down carpet and acrylic, latex and pressure sensitive adhesives
from concrete, terrazzo, ceramic tile and other surfaces. It is designed to soften carpet adhesive so that carpet
may be easily removed and to allow for easy scrape removal of the carpet adhesive. STICK-M-UP is water based
and is non-flammable. Does not contain: methylene chloride, benzene, toluene, phosphates, chlorinated
solvents or petroleum distillates.
Directions: Read and understand SDS when using this product.
To Remove Adhesive From Substrate (where floor covering has already been removed) Spray, pour or mop solution onto the adhesive making sure to completely cover the area to be worked. The floor area should not be allowed to dry. Make sure that “high areas” in the working area are kept wet. Allow at least 20 minutes dwell time before beginning to work the areas. Use scrapers or propane strippers with Nylo-Grit brushes or similar equipment. Discard removed adhesive and then rinse the floor with clean water, mop and allow to dry.
To Remove Glued Down Carpet
Cut the carpet into workable sections approximately 2 feet wide, spray, pour or mop solution onto the carpet making sure to completely cover the area to be worked. Use a carpet roller or squeegee to help spread the solution evenly. Allow the solution to dwell for at least 1 hour. If possible allow the solution to work overnight. If leaving the solution over night, cover the work area with plastic sheeting to prevent excessive evaporation. Pull up carpet sections by hand and immediately begin scrapping away residual adhesive. Once the residual adhesive is removed, rinse and mop with clean water and allow to dry.
To Remove Sheet Vinyl
Cut the sheet vinyl into workable sections approximately 2 feet wide. Pull up wear layer. Spray, pour or mop solution onto the sheet vinyl backing making sure to completely cover the area to be worked. Allow the solution to dwell for at least one hour. Do not allow the floor area to dry. Remove backing and adhesive with scraper. Once the residual adhesive is removed, rinse and mop with clean water and allow to dry.
Appearance: Colorless, clear liquid
Odor: Mint
Boiling Point: Not determined
Vapor Density: Not determined
pH: 11.5-12.5
Flash Point: > 93 C
DOT Shipping Class: 55
Shipping Weight: 5 gal. pail 31lbs.
Specific Gravity: 1.015 g/ml
Solubility: Complete in water
Coverage Rate: 150 – 400 sq. ft. over carpet
200-800 sq. ft over glue only
% Volatile/Volume: 97
HMIS Rating: 1-1-0
DOT Shipping NOT DOT REGULATED
$93.50 ea. (Pay $89.50available for pallets of 36 with free freight)
This product is also available as a concentrate 4×1 Gal Case $129.95 per case
You must be logged in to post a comment.