Serum Products, Mold Prevention, Serum 2000 Step-2 Polymer Coating, 5 Gallons

Serum 2000®

Prevents Stain Damage from Organic Matter

Step 2 Polymer Coating

SERUM 2000 is a non-hazardous coating that prevents stains and odors caused by organic matter. It is a permanent interior coating that chemically attaches to any surface providing long term protection against unsightly stains caused by organic matter. The charged polymers prevent stains and odors from forming. SERUM 2000 eliminates stains and odors which could be caused by organic matter and the treated materials suffer no stain damage.

There are three effective methods of application for SERUM 2000, spraying with pump up tank sprayer, airless sprayer and fogging. Fogging is the least labor intensive method of application. Fogging will coat all surfaces and into cracks and crevices on interior surfaces. Fogging SERUM 2000 will greatly reduce the time normally required for HEPA filter air scrubbing to pass post remediation clearance testing.

The surface to be coated should be relatively dry (below 15% internal moisture) before application of SERUM 2000. SERUM 2000 applies clear and dries clear in about an hour or less (depending on temperature and humidity conditions). SERUM 2000 can be applied to any surface not harmed by water.

Once dry, SERUM 2000 is not affected by relative humidity conditions.

• A Permanent Protective Coating
• Dries Clear In Less Than One Hour
• Covers Up To 1000 sq. ft./Gallon
• Contains A Proprietary Super Binder For Adhesion
• Does Not Contain VOC s
• Harmless To All Surfaces Not Harmed By Water
• Non Hazardous As Defined In 40 CFR
• Biodegradable

DIRECTIONS FOR USE
Prior to treating the surface to be coated, use SERUM 1000 to remove organic and non-organic matter from the
surface to provide for maximum adherance of the SERUM 2000. Apply a soaking coat of SERUM 2000 to the
entire area to be treated. Depending on temperature and humidity the coating will dry to touch in less than an hour.
SERUM 2000 will soak into porous surfaces to protect the substrate as well as the surface. Once dry, SERUM
2000 will be invisible unless a colorant has been added for quality control purposes. Treated surfaces will remain
damage free for years.
DO NOT ALLOW TO FREEZE

CAUTIONS
Keep out of the reach of children. Do not ingest. When not in use, keep container tightly closed. Do not dispose
of unused portions into water ways, creeks, rivers, estuaries or oceans. Do not reuse empty container. Proper Personal Protection Equipment (PPE): use full face mask with filter cartridges such as 3M 60926 or equivalent, full
body protection suit with head and foot covers, chemical resistant gloves and boots, tape at the wrist over suit and
gloves to prevent unwanted exposure to the product. Change air filter cartridges at manufacturers recommended
frequency. Discard body suit after one use. DO NOT REUSE BODY SUIT.

Product Specification

MSDS

$335.50 Each