SENTINEL 770 ODORLESS DEGREASER & MASTIC REMOVER is designed to remove asphalt cutback adhesives and leave no residue when rinsed. Faster acting than products of similar strength, 770 removes mastic faster than other odorless products. New flooring may be installed once floors are rinsed and allowed to dry completely. 770 does not contain asbestos.
Sentinel 770 Odorless Degreaser & Adhesive Remover is designed to clean and remove black asphalt and solvent based mastics and clear thin spread adhesives commonly found under 9” and 12” vinyl floor tile. 770 is formulated with a 170˚ F flashpoint and carries a USDA-C1 approval rating.
**This Product May Not Be Shipped Into the Following States: CA, CT, DE, MA, MD, ME, MI, NJ, NY, OH, PA, RI**
|Size||:||5 gal Pail|
|VOC Content||:||15 g/L|
|Flash Point||:||171 Deg F|
Before beginning work, protect all walls, flooring, carpeting, cracks or wood with an aborbent from liquid materials. This will ensure easier clean-up and elimate potential problems
Wet the entire adhesive surface with 770. This may be done by spraying or mopping 770 over the surface of the mastic. Allow 770 to soak and penetrate into the mastic for 10 – 20 minutes.
Scrape or squeegee the bulk of the softened or liquefied mastic from the surface with a floor scraper (razor scraper) or floor squeegee.
Reapply 770 as in step one. Agitate with a short-bristled broom, hand-held or rotating floor scrubber with stripper pads to fully lift and liquefy adhesive residue from the subfloor. The liquid may then removed with absorbent.
Wash and rinse the floor thoroughly with a degreaser and water to ensure a clean surface. Allow to dry a minimum of 24 hours before installing new flooring.
Expect coverage rates of 100-200 sq. feet per gallon.
This Floor or Wall Covering Adhesive Remover contains less than 5% V.O.C. content by weight, in accordance with the requirements set forth by the California Air Resource Board (CARB) and Ozone Transport Commission (OTC), effective 1-1-2009.
Seller makes no warranty, expressed or implied, nor accepts any reponsibility for any direct or consequential damages beyond purchase price, because seller cannot control users handling and use or effect of that use.
Physical state: Liquid
Odor: Mild Solvent Odor
pH: Not Applicable
Boiling Point: 363-381° F.
Flash Point: 170° F.
Self Ignition Temperature: 421° F.
Vapor Pressure:<0.5 mm Hg@68° F.
VOC Content: <45g/l*
* When determining VOC content in accordance with the requirements set forth by the Ozone Transport Commission (OTC), effective 01-01-2009
HAZARD RATING: HMIS
PERSONAL PROTECTION H
available in 5 gal Pails $135.00 or 55 gal Drums $1350.00