Foam (Wet Expanding)
Heel & Scuff Marks
Hot Melt Glue
Labels & Tape
Oil-Based Paint & Stain (Fresh)
From virtually any surface including automobiles, dry paint, glass, porcelain, fiberglass, vinyl, wood and much more. Even from laundry, skin and hair. See directions below for list of prohibited surfaces.
NO HARMFUL VAPORS • No Benzene • No Xylene No Phosphates • No Toluene • No Chlorinated Solvents • Non-Corrosive • Non-Toxic • POWERFUL, YET GENTLE ON EQUIPMENT AND SURFACES.
Not recommended for use on: acrylic and some plastics, uncoated wallpaper, butyl, suede & leather (will darken), silk, elastic items and khaki-colored fabric. On rubber, wash off after use.
Apply. In most cases, let sit 20-30 seconds.
Wipe or scrape.
For tougher applications such as caulk, silicone and hardened floor adhesives, let sit 10-25 minutes before wiping. KEEP MOIST WITH INTERMITTENT SPRAYING and determine timing of bond release. Once determined, apply in necessary volume according to size of surface area.
IMPORTANT: Make sure surfaces that produce heat are cool before using CONTRACTORS SOLVENT on them. After use on equipment or elements that produce heat, remove product thoroughly with mild soap and water AND LET DRY BEFORE USING.
Before reapplying new adhesive to cleaned surface, make sure CONTRACTORS SOLVENT is rinsed and removed thoroughly, with water, or mild soap and water, and dry.
Not recommended on suede & leather (will darken), silk, elastic items and khaki-colored fabric.
Gently remove excess problem from fabric.
Saturate problem area on both sides of fabric (let work 1-2 minutes).
Blot area with paper towel.
Re-spray and launder according to item manufacturer’s directions.
IMPORTANT: DO NOT APPLY LIQUID DIRECTLY TO CARPET OR UPHOLSTERY OR ALLOW TO WET OR REACH CARPET BACKING. Use at your own risk on carpet.
Always test on an inconspicuous area.
Apply to clean cloth.
Blot problem area until removed.
Rinse with water.
Blot dry with clean cloth or paper towel.
For best results, extract with wet/dry vac, Bissell, etc.
You must be logged in to post a comment.